Easy Monster Hands

Ok, remember when you were getting ready to use the Frankenstein Plans to build your very own Frankenstein and it said you’d have to supply your own set of hands? Well unless you were able to run out to your local Halloween store and buy a pair of hands you were out of luck. And a Frankenstein without hands isn’t very scary now is it? Making your own hands isn’t that difficult though, and the crew over at Screaming Scarecrow Studios have created a simple tutorial on how to make really great looking monster hands using latex gloves, witches fingers, and some expanding foam. You’ll start by turning the glove inside out and cutting a small slit in the tips of the fingers of your rubber glove.  Once you’ve got your witches fingers securely inserted into each of the fingers you’ll need to get a 12″ piece of 1/2″ pvc pipe for an arm bone.  You’ll need to drill a hole in both the bottom and top of your pipe approximately an inch from the bottom.  Once you’ve got your holes drilled you’re going to thread some wire through the hole in the pipe to secure the hand to the bone. You’ll also need to secure the wire through the witch’s fingers which is what will keep the hand secured to the bone once its filled with foam.  Once you’ve got your hand securely wired to the arm bone you’re ready to add some foam.  You can hang the hand by threading another wire through the hole you drilled in the top of the pvc. It may take a while for the foam to fully cure (2 to 3 days), but once they’ve hardened you can remove the glove from around the hands.  You’ll need...

Cheap and easy Skeleton Hands...

Since many of the prop builds featured on HauntersList involve PVC frames it’s probably not a bad idea to post another tutorial on how to create hands for those frames.  LastHouse from HalloweenForum has a tutorial on how to make some gruesome looking skeletal hands that won’t take you too long and the cost is next to nothing. They’re made of styrofoam and wood dowels coated with a little hot glue and then painted.  The hardest part about this tutorial is melting the styrofoam to give them a more natural boney look.  Make sure to do this step in a well ventilated area as burning styrofoam can be highly toxic (it’s a good idea to wear a respirator).   Items needed to complete this include: Styrofoam Hot Glue Wooden dowels Drylock Paint...

Clay Skeletal Hands

There’s a great tutorial on how to craft some skeletal hands out of Crayola Model Magic and coat hangers at a site called Mousecave.  I’m not a good sculptor so I would normally shy away from something like this, but it sure seems super simple, and what could be easier than skeleton arms, right?     Items needed to complete this include: Coat hangers – 3 to 5, depending on the length of the forearm Craft wire – any solid single strand wire will do Marker pen Lineman’s pliers – any pliers will do, so long as you can cut and bend the wire Two-part epoxy – because it’s strong and sets fast Acrylic craft paint – black and white Soft paint brush and small mixing dish Paper towels Scissors Modeling tools – nothing fancy, just something to etch some jagged lines Crayola Model Magic –...