The Build of Giant Mushrooms...

Ever hear the phrase “Go big or go home”?  Well I’m pretty sure Rania Peet has, and her larger than life Halloween props sure live up to that standard.  This time she’s set her sites on The Build of Giant Mushrooms, and her finished fungi could not have turned out any better! Her mushroom build is broken down into three core parts: the stem, the cap and the underside gills.  Realistically, I could get the stem and the cap done, but I’d probably fail miserably on the gills. The top and bottom of the stem was made from 3/4″ plywood. She used (3) 2x4s in the center to create an approximately 18″ diameter stem. The 2×4’s are secured to the base using lag screws and washers for extreme strength and stability.  For her build, Rania was lucky enough to have access to a wood cable spool which provided the perfect oversized round base.  The stem was then wrapped with chicken wire. The build of the mushroom cap is pretty ingenious, it consists of a 1′ piece of 4×4 that is securely screwed to a sheet of plywood with lag screws.  She then proceeded to bore four holes through the four by four and ran some rigid electrical conduit through it. Once in place the conduit was bent to provide the cap with a more “mushroom” shaped appearance. Some 3/4″ poly-flex tubing was screwed to the end of the rigid conduit to give the cap a finished, rounded edge.  A layer of chicken wire was then added to the cap which was covered with a dense cheesecloth to hold the layers of spray foam. Think Rania bought a couple of cans of Great Stuff?  Guess again, because this is where she takes this project up a...


We are glad that you preferred to contact us. Please fill our short form and one of our friendly team members will contact you back.

Form is not available. Please visit our contact page.